WOOD STOVE ALARM
CHIMNEY FIRE FLUE ALERT
OVERHEAT ALARM - THERMOSTAT
THE ORIGINAL - I DESIGNED & STARTED SELLING THESE IN 1989

WOOD STOVE ALARM - THERMOSTATIC CONTROLLER
Did you ever wish you had a way to warn you if your flue got too hot or wanted to know when you needed to add wood without just sitting there watching. I put this kit together because over the past several years I have done some dumb or brain dead stuff. In the past 4 years on 3 occasions I lit the wood stove leaving flue and vents wide open to get it hot, then I got sidetracked, came back 20 minutes later to find the flue pipe red and the magnetic thermostat buried at 1100 degrees.

The last time I did this the chimney was making so much noise I thought that the house was on fire. I called the fire department, the chimney overheated but thank God there was no serious damage.

After some research and some new technology I built this flue alarm and I will share the wealth and sell you one too.

Easy Set-Up,  internal open / close relay triggers when set temperature is reached. Have it warn you when it is too cold or too hot.

Install info:
Unit can be wired two ways:
Set High Temp - When High Temperature Reached - Alarm Sounds.
Set Low Temp - When Low Temperature is reached  - Alarm Sounds 

Takes about 10 minutes to hookup.

Setting Temperature takes about 5 Seconds - So you can RE-SET to turn off alarm or mount a on / off switch not included. I do not suggest a on / off switch - in case you forget to turn it on. 

This unit will handle a 15 amp load, so you can add a 110v AC Alarm if you want.

THIS IS WHAT YOU ARE GETTING: 

• Thermostatic Control Module - 110v - Programmed for " J " Thermo Probe.
• " J " Thermo probe -  4" long with 48" wire.
• Probe Mount - Screws on flue pipe - 4.5" long.
• 110db alarm - Powered by a 9 volt battery - Can be mounted up to 50' away from control module using speaker wire - not included.

Part #	Description	Price
WS-ALARM-001	Wood Stove Alarm Kit -  Includes Control Module, J probe and mount, Alarm.	$195.95
WS-CONTROL-001	Wood Stove Alarm Kit  - as above less ALARM.	$179.95

Yes this control module can be used to control any 15 amp circuit - including a blower.

FEEL FREE TO CALL WITH ANY
QUESTION OR ORDERS
 845-786-0620

CLICK ABOVE IMAGE
I ADDED A WIRELESS IP CAMERA 
TO MY ALARM FOR ANYWHERE MONITORING

CAMERA IS NOT INCLUDED WITH KIT
JUST POSTED TO SHOW YOU